Do you need to change the oil in your Toyota Corolla? Here’s how. Spun Rayon Fabric,Print Fabric,Crepe Yoryu Fabric,100% Viscose Fabric Shaoxing MingFang Textile Co., Ltd , https://www.printingsfabric.com
Toyota Corolla Maintenance – Oil Change
Is your Toyota Corolla due for an oil change? If you're looking to save money and take on a simple DIY task, changing the oil yourself is a great way to keep your car running smoothly. Here's a step-by-step guide to help you through the process.
Genuine Toyota maintenance parts: here
Before starting, make sure you have a flat, stable surface to work on. A clean garage or driveway with good lighting is ideal. Gather all the tools and materials you’ll need:
- Oil collection pan
- 4 quarts of motor oil (check your owner’s manual for the correct type)
- New oil filter
- Funnel
- Rags or paper towels
- Socket wrench set
- Oil filter wrench or socket
There's some debate about how often to change your oil. Traditionally, it was every 3,000 miles or 3 months, but modern vehicles like the Toyota Corolla can go longer, especially if using synthetic oil. Toyota recommends changing oil every 5,000 miles or 6 months with conventional oil, and up to 10,000 miles or 1 year with 0W-20 synthetic oil. Always follow the guidelines in your owner’s manual.
### Step-by-Step Oil Change Guide
1. **Locate the Drain Plug**: Open the hood and find the oil drain plug under the engine.
2. **Position the Pan**: Place an oil collection pan underneath the drain plug.
3. **Loosen the Drain Plug**: Use a 14mm socket and wrench to loosen the plug. Once loose, remove it completely to let the old oil drain out.
4. **Drain the Oil**: Allow the oil to drain fully—this may take a few minutes.
5. **Remove the Oil Filter**: Locate the oil filter and use an oil filter wrench or socket to remove it.
6. **Dispose of Old Oil**: Carefully pour the oil from the filter into the pan. Let any remaining oil drip out.
7. **Clean the Area**: Wipe around the oil filter housing with a rag to remove any residue.
8. **Prepare the New Filter**: Apply a thin layer of new oil to the rubber gasket of the new oil filter.
9. **Install the New Filter**: Screw the new filter on by hand until it's snug. Don’t over-tighten.
10. **Reinstall the Drain Plug**: Put the drain plug back in place and tighten it with a wrench—be careful not to over-tighten.
11. **Add New Oil**: Open the hood, remove the oil cap, and pour in 3.5 to 4 quarts of fresh oil. Use a funnel to avoid spills.
12. **Check the Level**: After adding oil, check the dipstick to ensure the level is correct. Add more if needed.
Once done, don’t forget to reset the oil change indicator light. Turn the key to the "ACC" position, set the odometer to "Trip," then turn off the key. Press and hold the trip button while turning the key back to "ACC." The light should blink and reset.
That’s it! You’ve just completed an oil change on your Toyota Corolla. It’s a simple, cost-effective way to maintain your vehicle and keep it running at its best.
**Related Posts:**
- [Toyota Camry Maintenance – Oil Change](#)
- [Toyota Tundra Maintenance – Change Oil and Oil Filter](#)
- [Toyota Sienna Maintenance – Replace Cabin Air Filter](#)
- [Scion tC Maintenance – Shock and Spring Replacement](#)
- [Toyota FJ Cruiser Maintenance – Replace Spark Plugs](#)
- [Toyota Tundra Maintenance – Change Brake Pads](#)