Determine the routing and processing sequence

The path of the knife is the trajectory of the tool in the entire machining process. It not only includes the content of the work step, but also reflects the order of the work process. The route of a knife is one of the basis for writing a program. The following points should be noted when determining the cutting path:

1. Seek the shortest processing route and reduce the time of empty knife to improve processing efficiency

For example, the hole system on the part shown in Figure 1a. In the figure, the tool path is to machine the hole in the outer ring after machining the hole in the outer ring. If you use the cutting path of c, you can save nearly double the positioning time.

a

b

c

Fig. 1 Design of the shortest path

2. In order to ensure the roughness requirements of the workpiece contour surface after processing, the final contour should be arranged in the last pass in a continuous processing

As shown in Fig. 2a, the cutting path of the inner cavity is processed in a line cutting manner. This kind of cutting can cut off the entire margin in the inner cavity, leaving no dead corner and no damage to the outline. However, the line cutting method will leave a residual height between the start point and the end point of the two passes, but not the required surface roughness. Therefore, if the cutting path of the b-chart is adopted, the first line cutting method is used, and finally a circumferential knife is cut around the surface to smooth the surface of the profile and a good effect can be obtained. Figure 2c is also a better way to go.

a

b

c

Figure 2 Three cutting paths for milling the cavity

3. Consider the route of entering and retracting (cut in, cut out) the tool

The cut-out point or cutting-in point of the tool should be along the tangent of the contour of the part to ensure the smooth contour of the workpiece; it should avoid vertically scratching the surface of the workpiece on the contour surface of the workpiece; minimize the pause in the contour machining cutting process. (Sudden change in cutting force causes elastic deformation), so as not to leave a knife mark, as shown in Figure 3.

Figure 3 The extension of the tool when cutting in and out

4. Select the route to make the workpiece deform after processing

For thin or thin parts with small cross-sectional area, the cutting path should be arranged by several passes to the final size or symmetrical removal margin method.

5. First arrange for less damage to the workpiece

Butt Fusion Machines

The polyethylene butt fusion machine is the most used with the same butt welding device, and these devices are produced and supplied from 40 to 3000 mm, and capable of welding up to a pressure of 40 atmospheres. Yuda brand plastic pipe fusion machines are based on the standard DVS2207. This company's polyethylene welding machine is designed to be unique for carrying out work on site and workshop environment. Polyethylene pipe fusion machines are manufactured using the best quality raw materials available on the market, and the company's pipe welding machines are certified by the inspectors of the water supply and power plant, and all products with warranty and after service sales are offered. These polyethylene welding machines are tested, calibrated after producing.

There are types of HDPE Plastic Pipe Butt Fusion Machines; Manual Butt Fusion Machines is the most cheapest in all series. Hydraulic butt fusion machines are used most in piping engineering. For welding quality control, it will choose data logger for hydraulic hdpe welders named data-logging pipe welding machine.Then the toppest level is CNC Welding machine for polyplastic pipes which is the most expensive and comprehensive poly pipe butt welders, CNC welding and GPS and CLOUD system is its unique feature.

Butt Fusion Machine,Fusion Machine,Fusion Equipment,Butt Fusion Welding Machine

WUXI MEIERTE MACHINERY TECHNOLOGY CO.,LTD , https://www.wxpipefusionweldings.com